# Dead ends - options for how to treat? **URL:** \ **Category:** Yarbo Lawn Mower\ **Created:** [August 24, 2026, 11:23am UTC](https://forum.yarbo.com/t/dead-ends-options-for-how-to-treat/7360 "2026-08-24T11:23:13Z")\ **Posts on this page:** 3\ **Page:** 1
**Author:** ![marriott001](https://yyz1.discourse-cdn.com/flex007/user_avatar/forum.yarbo.com/marriott001/32/991_2.png) [@marriott001](https://forum.yarbo.com/u/marriott001)\ **Post date:** [August 24, 2026, 11:23am UTC](https://forum.yarbo.com/t/dead-ends-options-for-how-to-treat/7360/1 "2026-08-24T11:23:13Z")
Maybe it was just the snowblower, but are there any settings on how yarbo should act after doing a dead end mowing? I have a couple edging passes that use deadends since the area doesn’t cut close enough. But yarbo seems to have a tough time reversing back out without hitting its bumpers. ---
**Author:** ![bryan.wheeler](https://yyz1.discourse-cdn.com/flex007/user_avatar/forum.yarbo.com/bryan.wheeler/32/215_2.png) [@bryan.wheeler](https://forum.yarbo.com/u/bryan.wheeler)\ **Post date:** [August 24, 2026, 1:02pm UTC](https://forum.yarbo.com/t/dead-ends-options-for-how-to-treat/7360/2 "2026-08-24T13:02:19Z")
No options that I’m aware of. You need to make the entrance out in an open area with lots of room for it to maneuver. It can come at it from any angle when entering and exiting. ---
**Author:** ![Yarbo-Forum](https://yyz1.discourse-cdn.com/flex007/user_avatar/forum.yarbo.com/yarbo-forum/32/126_2.png) [@Yarbo-Forum](https://forum.yarbo.com/u/Yarbo-Forum)\ **Post date:** [August 25, 2026, 7:37am UTC](https://forum.yarbo.com/t/dead-ends-options-for-how-to-treat/7360/3 "2026-08-25T07:37:34Z")
Currently, there isn’t a setting to customize Yarbo’s behavior after completing a Dead End. Once it reaches the end of the Dead End path, Yarbo will reverse back out along the path.