# Yarbo Snow Blower Module - Auger and impeller gearbox lubrication? **URL:** \ **Category:** Yarbo Snowblower\ **Created:** [October 1, 2026, 7:54pm UTC](https://forum.yarbo.com/t/yarbo-snow-blower-module-auger-and-impeller-gearbox-lubrication/7704 "2026-10-01T19:54:03Z")\ **Posts on this page:** 3\ **Page:** 1
**Author:** ![franktan](https://yyz1.discourse-cdn.com/flex007/user_avatar/forum.yarbo.com/franktan/32/7932_2.png) [@franktan](https://forum.yarbo.com/u/franktan)\ **Post date:** [October 1, 2026, 7:54pm UTC](https://forum.yarbo.com/t/yarbo-snow-blower-module-auger-and-impeller-gearbox-lubrication/7704/1 "2026-10-01T19:54:03Z")
I do see the auger/impeller shafts and gearbox, but I don’t see any access to maintain or lubricate the gear box? Traditional snow blowers have grease fittings, etc… So, just assume these Yarbo snow blower module gear boxes and shafts don’t need lubrication? ---
**Author:** ![bryan.wheeler](https://yyz1.discourse-cdn.com/flex007/user_avatar/forum.yarbo.com/bryan.wheeler/32/215_2.png) [@bryan.wheeler](https://forum.yarbo.com/u/bryan.wheeler)\ **Post date:** [October 1, 2026, 8:07pm UTC](https://forum.yarbo.com/t/yarbo-snow-blower-module-auger-and-impeller-gearbox-lubrication/7704/2 "2026-10-01T20:07:26Z")
They have stated that they do not need it. There is currently no way to do that either. It would be nice if there was a zerk fitting or something where you could though. ---
**Author:** ![Stoneslinger76](https://yyz1.discourse-cdn.com/flex007/user_avatar/forum.yarbo.com/stoneslinger76/32/371_2.png) [@Stoneslinger76](https://forum.yarbo.com/u/Stoneslinger76)\ **Post date:** [October 4, 2026, 1:20pm UTC](https://forum.yarbo.com/t/yarbo-snow-blower-module-auger-and-impeller-gearbox-lubrication/7704/3 "2026-10-04T13:20:16Z")
Yes a gease fitting for outer blower bearings, drain and a plug for the center differential would be very good.