For months snowblower has worked almost flawlessly, even when I’m out of the country. No, it’s a disatser. Constant auger overcurrent issues. Almost always at the end of a “line” on the plan when it goes to turn around. If you pause, go into remote control, drive 1 inch and then clear the error, i…

I’ve been having the same issues and in the meantime I’m working on designing a little relief grommet that can house the module plug wiring cable and slot into the plastic cover. Aiming for a very snug fit on the cable to avoid the M25 connector getting pulled around too much during module movement…

To be clear, this is the space i’m looking to add the grommet: [image]

Really sorry to hear about all the issues you’re running into—this definitely sounds frustrating, especially given how well the snow blower was working for you before. As Bryan mentioned, the repeated module disconnected alerts may be related to the M25 connector, which we’re actively investigating…

I’m seeing some of these issues after the firmware update, but thankfully no where near the frequency described by “rrr”. Like “rrr”, my snowblower functioned pretty much perfectly all of last season and this season until the latest firmware update. Immediately after the update, I began noticing: (…

Good summary. I’ve definitely seen the smart vision issues you’re describing.

After updating to the newest firmware… I have also seen the periodic out of sync video issue. For me, closing smart vision and restarting it seems to resolve it. I’ve also been seeing where Yarbo will just sort of pause while in the middle of a work plan. It seems to me the auger’s power is cut,…

My blower also started showing module disconnect and module connect messages after yesterday. In any case, I also have a mechanical motor problem, so I assumed those surge peaks could be causing this issue as well. I already checked the connector and it looks fine. On the other hand, because of the…

My m25 connector also “looks fine” and has no perceptable play, but sure enough when I have disconnects (or endless waiting for auger messages) that don’t recover on their own a gentle push of the cord towards the module plug would get everything back going again (or 9/10 times just adjusting the mo…

Snowblower pretty much unusable after latest firmware update

Support & Solutions

bryan.wheeler January 27, 2026, 2:09am 2

It sounds like you have an M25 connector issue to me. What is your ticket number? The forum admin can take a look and help escalate this.

Snowblower pretty much unusable after latest firmware update

Topic		Replies	Views
Snowblower pretty much unusable after latest firmware update Support & Solutions	2	77	January 27, 2026
Had a hard time with the remote/app getting the augur working Yarbo Snowblower	11	78	January 30, 2026
Camera issues Software Issues snowblower	103	313	April 3, 2026
Snowblower - Module Disconnected Support & Solutions	23	271	February 2, 2026
Firmware V3.12.0 & App V3.17.4 Release Notes & Feature Highlights Updates & Product Releases	184	2217	April 14, 2026

Snowblower pretty much unusable after latest firmware update

Related topics